convert a VMDK into a VHD ?

Ali 1 Reputation point
2021-09-29T06:10:45.407+00:00

Is there any manual way to convert a VMDK to a VHD ?

I have tried all the tools Starwind, Winimage, disk2vhd etc they all generate a VHD file but when I create a ne Virtual Computer & attach the disk none works.

I get repeated errors "The virtual machine "New Virtual Machine" could not start because the hypervisor is not running"

I googled it & did enable DEP but that does not result in success.

In past i convrted a VHD to VMDK succesfully using the solution here

http://alstechtips.blogspot.com/2013/11/how-to-migrate-vhd-to-vmware-workstation.html

Is there a possibillity of converting the VMDK to VHD using an approach similar to the one in above mentioned article ?

Help would be appreciated. Thanks

Hyper-V
Hyper-V
A Windows technology providing a hypervisor-based virtualization solution enabling customers to consolidate workloads onto a single server.
2,546 questions
0 comments

3 answers

Sort by: Most helpful
Most helpful Newest Oldest
  1. Leon Laude 85,666 Reputation points
    2021-09-29T06:32:00.413+00:00

    Hi @Ali ,

    The above mentioned tools should all work for converting, I don't believe the problem is with the conversion tools but somewhere else, if you enabled your processor's virtualization technology in the BIOS and Hyper-V is still complaining about the "The virtual machine "New Virtual Machine" could not start because the hypervisor is not running" error then you could try uninstalling Hyper-V and then try reinstalling it completely.

    ----------

    If the reply was helpful please don't forget to upvote and/or accept as answer, thank you!

    Best regards,
    Leon

    0 comments
  2. Limitless Technology 39,371 Reputation points
    2021-09-29T14:06:42.36+00:00

    Hello,

    Thank you for your question.

    All above tools are good and proven tools for this conversions.

    1. In your case Please try to create new Hyper-V VM and try to boot it .
    2. Please try to disable any Antivirus program for temporary purpose.
    3. In CMD
      bcdedit /set hypervisorlaunchtype auto -> reboot and try again

    --If the reply is helpful, please Upvote and Accept as answer--

    0 comments
  3. Ali 1 Reputation point
    2021-09-29T14:30:21.8+00:00

    Reinstalling the Hypervisor lead to new errors in which it says

    boot failure. Reboot & select proper Boot Device ( proper devices are selected in Bios in Hyper V) , I did boot the disk into the cmd mode & then tried bootrec /fixmbr which worked but when I try bootrec/fixboot it says "access denied" , I did rebuild the MBR but still the same error that cannot boot from disk

    0 comments