Remove-RetentionCompliancePolicy

This cmdlet is available only in Security & Compliance Center PowerShell. For more information, see Security & Compliance Center PowerShell.

Use the Remove-HoldCompliancePolicy cmdlet to remove retention policies from the Microsoft 365 compliance center. This cmdlet also removes the corresponding retention rule.

For information about the parameter sets in the Syntax section below, see Exchange cmdlet syntax.

Syntax

Remove-RetentionCompliancePolicy
      [-Identity] <PolicyIdParameter>
      [-Confirm]
      [-ForceDeletion]
      [-WhatIf]
      [<CommonParameters>]

Description

New policies are not valid and will not be applied until a retention rule is added to the policy. In addition, at least one location parameter must be defined to create a retention policy.

To use this cmdlet in Security & Compliance Center PowerShell, you need to be assigned permissions. For more information, see Permissions in the Microsoft 365 compliance center.

Examples

Example 1

Remove-RetentionCompliancePolicy -Identity "Regulation 123 Compliance"

This example removes the retention policy named "Regulation 123 Compliance".

Parameters

-Confirm

The Confirm switch specifies whether to show or hide the confirmation prompt. How this switch affects the cmdlet depends on if the cmdlet requires confirmation before proceeding.

  • Destructive cmdlets (for example, Remove-* cmdlets) have a built-in pause that forces you to acknowledge the command before proceeding. For these cmdlets, you can skip the confirmation prompt by using this exact syntax: -Confirm:$false.
  • Most other cmdlets (for example, New-* and Set-* cmdlets) don't have a built-in pause. For these cmdlets, specifying the Confirm switch without a value introduces a pause that forces you acknowledge the command before proceeding.
Type:SwitchParameter
Aliases:cf
Position:Named
Default value:None
Accept pipeline input:False
Accept wildcard characters:False
Applies to:Security & Compliance Center
-ForceDeletion

The ForceDeletion switch forces the removal of the retention policy. You don't need to specify a value with this switch.

Type:SwitchParameter
Position:Named
Default value:None
Accept pipeline input:False
Accept wildcard characters:False
Applies to:Security & Compliance Center
-Identity

The Identity parameter specifies the retention policy that you want to remove. You can use any value that uniquely identifies the policy. For example:

  • Name
  • Distinguished name (DN)
  • GUID
Type:PolicyIdParameter
Position:1
Default value:None
Accept pipeline input:True
Accept wildcard characters:False
Applies to:Security & Compliance Center
-WhatIf

The WhatIf switch doesn't work in Security & Compliance Center PowerShell.

Type:SwitchParameter
Aliases:wi
Position:Named
Default value:None
Accept pipeline input:False
Accept wildcard characters:False
Applies to:Security & Compliance Center

Inputs

Outputs