question

anthonydavis-5715 avatar image
0 Votes"
anthonydavis-5715 asked ChrisN-4866 published

Cutover Migration ( From Exchange 2013 to O365 Online)

60996-cutover-migraiton-issue-frrom-exchange-2013-on-pre.jpg



Hey Forum,

I'm trying to create a "Migration Batch" from Exchange 2013 to O365 and I'm getting an error message that says the following:

Batch creation failed!
The 'TargetDeliveryDomain' parameter isn't supported for migrations using the 'ExchangeOutlookAnywhere' protocol.

I'm not sure how to fix this, I'm not really sure what this means.

Any help is appreciated.

Techno Guy

office-exchange-server-administration
· 2
5 |1600 characters needed characters left characters exceeded

Up to 10 attachments (including images) can be used with a maximum of 3.0 MiB each and 30.0 MiB total.

Hi @anthonydavis-5715

Is there any update about your question?

0 Votes 0 ·

Hi @anthonydavis-5715

Do suggestions below help?

0 Votes 0 ·
AndyDavid avatar image
0 Votes"
AndyDavid answered AndyDavid edited
5 |1600 characters needed characters left characters exceeded

Up to 10 attachments (including images) can be used with a maximum of 3.0 MiB each and 30.0 MiB total.

joyceshen-MSFT avatar image
0 Votes"
joyceshen-MSFT answered

Hi @anthonydavis-5715

Agree with the suggestion above from Andy, please make sure you have Prepared for a cutover migration list in the official document.

In addition, according to this: Use PowerShell to perform a cutover migration to Microsoft 365

The TargetDeliveryDomain parameter seems not being used in the cutover scenario within New-MigrationBatch. You may also try using powershell to finish the migration.


If an Answer is helpful, please click "Accept Answer" and upvote it.

Note: Please follow the steps in our documentation to enable e-mail notifications if you want to receive the related email notification for this thread.
 

5 |1600 characters needed characters left characters exceeded

Up to 10 attachments (including images) can be used with a maximum of 3.0 MiB each and 30.0 MiB total.

JimGonzalez-7204 avatar image
1 Vote"
JimGonzalez-7204 answered

I had the same problem with Exchange 2010. I switched to classic view in Exchange Admin Center and created the batch without errors

5 |1600 characters needed characters left characters exceeded

Up to 10 attachments (including images) can be used with a maximum of 3.0 MiB each and 30.0 MiB total.

SergioVillarroel-7990 avatar image
1 Vote"
SergioVillarroel-7990 answered

Today (16-oct-2021) I had the same problem, so I followed the advice of JimGonzalez-7204 (switch to the classic) and everything was ok.

5 |1600 characters needed characters left characters exceeded

Up to 10 attachments (including images) can be used with a maximum of 3.0 MiB each and 30.0 MiB total.

ChrisN-4866 avatar image
0 Votes"
ChrisN-4866 answered ChrisN-4866 published

Agreed, this seems to be an issue with the new exchange admin centre. I too switched to classic and everything was ok.

5 |1600 characters needed characters left characters exceeded

Up to 10 attachments (including images) can be used with a maximum of 3.0 MiB each and 30.0 MiB total.