question

EavenHuang avatar image
0 Votes"
EavenHuang asked KaelYao-MSFT commented

how long for exchange email account to take effect after on-premise AD user is re-enabled

Dear experts,

We have on-premise AD domain and office 365 merged. Some users were disabled and after I re-enabled them from our AD console, is there an official document mentioning how long it take exchange to synchronize the state and give them access again?

I tried to reset password on my test account and it took around 15 mins to ask me to enter my new password. Thanks.

office-exchange-server-administration
5 |1600 characters needed characters left characters exceeded

Up to 10 attachments (including images) can be used with a maximum of 3.0 MiB each and 30.0 MiB total.

KaelYao-MSFT avatar image
0 Votes"
KaelYao-MSFT answered KaelYao-MSFT commented

Hi @EavenHuang-0590

Are you using Azure AD connect sync to sync the AD accounts?
If so, I suppose that the changes would be synced after the Azure AD connect sync schedule.

And to assign them access to the mailboxes, you may need to make sure the required licenses are assigned to these accounts.

I didn't find any document introducing the detailed time for it to take effort, while it shouldn't take too much time.


If the response is helpful, please click "Accept Answer" and upvote it.
Note: Please follow the steps in our documentation to enable e-mail notifications if you want to receive the related email notification for this thread.

· 3
5 |1600 characters needed characters left characters exceeded

Up to 10 attachments (including images) can be used with a maximum of 3.0 MiB each and 30.0 MiB total.

Hi @EavenHuang-0590

I am writing here to confirm with you how thing going now?
If you have any questions or needed further help on this issue, please feel free to post back.

0 Votes 0 ·

Hi @KaelYao-MSFT,

Thanks a lot for sharing the info. So it was supposed to be "By default every 30 minutes a synchronization cycle is run ", is it correct?

We are using Azure AD connect sync to sync the AD accounts, however I didn't find the commands via PowerShell, any idea how to get it work?

121411-adsync.png


0 Votes 0 ·
adsync.png (105.4 KiB)

Hi,
Sorry for the late reply.
Did you run the command on the device which has Azure Active Directory Connect installed?

0 Votes 0 ·
Dev073 avatar image
1 Vote"
Dev073 answered EavenHuang commented

Hi - Looks the module is not available in any of the module directory hence this error.

Check this articles to get this fixed.

https://azurelessons.com/the-specified-module-adsync-was-not-loaded/

· 1
5 |1600 characters needed characters left characters exceeded

Up to 10 attachments (including images) can be used with a maximum of 3.0 MiB each and 30.0 MiB total.

Hi @Dev073,

This article didn't help because I don't have that Microsoft Azure AD connect, so I guess that's because I didnt Install Azure Active Directory Connect?

Thanks.

0 Votes 0 ·