Routing and Remote Access Service Configuration

Question

question

MohammadShamie-3282 asked Apr 18, '22 MohammadShamie-3282 answered Apr 20, '22

Routing and Remote Access Service Configuration

Hi all ,

After configuring a RRAS service on 2019 windows server, I was able to have an internet access from the server, but I am not able to ping any of RRAS clients even though I can ping the server IP, not able also to reach any local service, The IPv4 router checkbox is checked , LAN and demand dail routing is chosen.

I was trying to connect to this server so that only RRAS clients can access the server's services, by closing firewall to the server's public IP, but that didn't work also since it still recognizes my local public IP.

So can you propose me a solution?

Thanks in advance ,

windows-server windows-server-infrastructure msc-essentials

5 |1600 characters needed characters left characters exceeded

Attachments: Up to 10 attachments (including images) can be used with a maximum of 3.0 MiB each and 30.0 MiB total.

Answer 1 · 2022-04-18T17:36:02.707Z

VitoProcino-4399 answered Apr 18, '22

Hi,

You check configuration NPS policy and routing ip address dhcp client.

Check on target, windows firewall policy setting to permit access from ip address of dhcp client.

5 |1600 characters needed characters left characters exceeded

Attachments: Up to 10 attachments (including images) can be used with a maximum of 3.0 MiB each and 30.0 MiB total.

Answer 2 · 2022-04-20T06:41:44.627Z

MohammadShamie-3282 answered Apr 20, '22

Hii VitoProcino-4399,

Thanks for your response, actually I checked these policies and configurations and all are set, but still same issue.
Below is a screenshot for firewall port configuration.

Thanks,

image.png (10.9 KiB)

5 |1600 characters needed characters left characters exceeded

Attachments: Up to 10 attachments (including images) can be used with a maximum of 3.0 MiB each and 30.0 MiB total.

question