# SKPath.RCubicTo Method

## Definition

## Overloads

RCubicTo(SKPoint, SKPoint, SKPoint) |
Same as CubicTo(SKPoint, SKPoint, SKPoint) but the coordinates are considered relative to the last point on this contour. |

RCubicTo(Single, Single, Single, Single, Single, Single) |
Same as CubicTo(Single, Single, Single, Single, Single, Single) but the coordinates are considered relative to the last point on this contour. |

## RCubicTo(SKPoint, SKPoint, SKPoint)

Same as CubicTo(SKPoint, SKPoint, SKPoint) but the coordinates are considered relative to the last point on this contour.

`public void RCubicTo (SkiaSharp.SKPoint point0, SkiaSharp.SKPoint point1, SkiaSharp.SKPoint point2);`

#### Parameters

- point0
- SKPoint

The amount to add to the coordinates of the last point on this contour, to specify the 1st control point on a cubic curve.

- point1
- SKPoint

The amount to add to the coordinates of the last point on this contour, to specify the 2nd control point on a cubic curve.

- point2
- SKPoint

The amount to add to the coordinates of the last point on this contour, to specify the end point on a cubic curve.

### Remarks

If no MoveTo call has been made for this contour, the first point is automatically set to (0, 0).

## RCubicTo(Single, Single, Single, Single, Single, Single)

Same as CubicTo(Single, Single, Single, Single, Single, Single) but the coordinates are considered relative to the last point on this contour.

`public void RCubicTo (float dx0, float dy0, float dx1, float dy1, float dx2, float dy2);`

#### Parameters

- dx0
- Single

The amount to add to the x-coordinate of the last point on this contour, to specify the 1st control point on a cubic curve.

- dy0
- Single

The amount to add to the y-coordinate of the last point on this contour, to specify the 1st control point on a cubic curve.

- dx1
- Single

The amount to add to the x-coordinate of the last point on this contour, to specify the 2nd control point on a cubic curve.

- dy1
- Single

The amount to add to the y-coordinate of the last point on this contour, to specify the 2nd control point on a cubic curve.

- dx2
- Single

The amount to add to the x-coordinate of the last point on this contour, to specify the end point on a cubic curve.

- dy2
- Single

The amount to add to the y-coordinate of the last point on this contour, to specify the end point on a cubic curve.

### Remarks

If no MoveTo call has been made for this contour, the first point is automatically set to (0, 0).