18.104.22.168.32.5 IVdsVolume::Shrink (Opnum 7)
HRESULT Shrink( [in] ULONGLONG ullNumberOfBytesToRemove, [out] IVdsAsync** ppAsync );
ullNumberOfBytesToRemove: The number of bytes by which to shrink the volume.
ppAsync: A pointer to an IVdsAsync interface that, if the operation is successfully completed, receives the IVdsAsync interface to monitor and control this operation. Callers MUST release the interface when they are done with it.
Return Values: The method MUST return zero or a non-error HRESULT (as specified in [MS-ERREF]) to indicate success, or return an implementation-specific nonzero error code to indicate failure. For the HRESULT values predefined by the Virtual Disk Service Remote Protocol, see section 2.2.3.
When the server receives this message, it MUST validate the following parameter:
Verify that ppAsync is not NULL.<115>
The server MUST perform the following:
Create a new async object implementing the IVdsAsync interface with an output type of VDS_ASYNCOUT_SHRINKVOLUME and set the pointer ppAsync references to the interface.
Return an HRESULT indicating failure or success. Any errors encountered up through this point in processing the operation are returned in this HRESULT.
The server MUST then perform the following in sequence. Errors generated in this sequence of steps are returned in the pHrResult parameter to the IVdsAsync::Wait or IVdsAsyncQueryStatus methods.
Shrink the volume following the parameters specified to the method.
objectType member is VDS_NTT_VOLUME.
The volume member is a VDS_VOLUME_NOTIFICATION with the following attributes:
ulEvent is VDS_NF_VOLUME_MODIFY.
volumeId is the VDS_OBJECT_ID of this volume object.
plexId is NULL GUID, but it is not relevant when ulEvent is VDS_NF_VOLUME_MODIFY.
ulPercentCompleted range is 0-100 and is implementation-specific; however, it is not relevant when ulEvent is VDS_NF_VOLUME_MODIFY.
Set the return code in the async object to an HRESULT indicating failure or success.
If the task completed successfully, set the percentage completed value in the async object to 100.<117>
Set the signal state in the async object to TRUE.
The server MUST update the percentage completed value periodically during the preceding sequence. How often the percentage completed is updated, and at what point in the sequence, is implementation-specific.