Set-ExchangeServer

The Confirm switch specifies whether to show or hide the confirmation prompt. How this switch affects the cmdlet depends on if the cmdlet requires confirmation before proceeding.

• Destructive cmdlets (for example, Remove-* cmdlets) have a built-in pause that forces you to acknowledge the command before proceeding. For these cmdlets, you can skip the confirmation prompt by using this exact syntax: -Confirm:$false.

• Most other cmdlets (for example, New-* and Set-* cmdlets) don't have a built-in pause. For these cmdlets, specifying the Confirm switch without a value introduces a pause that forces you acknowledge the command before proceeding.

The CustomerFeedbackEnabled parameter specifies whether the Exchange server is enrolled in the Microsoft Customer Experience Improvement Program (CEIP). The CEIP collects anonymous information about how you use Exchange and problems that you might encounter. If you decide not to participate in the CEIP, the servers are opted-out automatically.

The DomainController parameter specifies the domain controller that's used by this cmdlet to read data from or write data to Active Directory. You identify the domain controller by its fully qualified domain name (FQDN). For example, dc01.contoso.com.

The DomainController parameter isn't supported on Edge Transport servers. An Edge Transport server uses the local instance of Active Directory Lightweight Directory Services (AD LDS) to read and write data.

The ErrorReportingEnabled parameter specifies whether error reporting is enabled.

The Identity parameter specifies the Exchange server that you want to modify. You can use any value that uniquely identifies the server. For example:

• Name

• FQDN

• Distinguished name (DN)

• Exchange Legacy DN

The InternetWebProxy parameter specifies the web proxy server that the Exchange server uses to reach the internet. A valid value for this parameter is the URL of the web proxy server.

In Exchange 2016 or later, to configure a list of servers that bypass the web proxy server and connect to the internet directly, use the InternetWebProxyBypassList parameter.

The InternetWebProxyBypassList parameter specifies a list of servers that bypass the web proxy server specified by the InternetWebProxy parameter. You identify the servers by their FQDN (for example, server01.contoso.com).

To enter multiple values and overwrite any existing FQDN entries, use the following syntax: <FQDN1>,<FQDN2>,...<FQDNX>.

To add or remove one or more values without affecting any existing FQDN entries, use the following syntax: @{Add="<FQDN1>","<FQDN2>"...; Remove="<FQDN1>","<FQDN>"...}.

The maximum number of servers you can enter with this parameter is 100.

The MonitoringGroup parameter specifies how to add your Exchange servers to monitoring groups. You can add your servers to an existing group or create a monitoring group based on location or deployment, or to partition monitoring responsibility among your servers.

The ProductKey parameter specifies the server product key.

The StaticConfigDomainController parameter specifies whether to configure a domain controller to be used by the server via Directory Service Access (DSAccess).

The StaticDomainControllers parameter specifies whether to configure a list of domain controllers to be used by the server via DSAccess.

The StaticExcludedDomainControllers parameter specifies whether to exclude a list of domain controllers from being used by the server.

The StaticGlobalCatalogs parameter specifies whether to configure a list of global catalogs to be used by the server via DSAccess.

The WhatIf switch simulates the actions of the command. You can use this switch to view the changes that would occur without actually applying those changes. You don't need to specify a value with this switch.