Remove-LabelPolicy

Module:
ExchangePowerShell
Applies to:
Security & Compliance Center

This cmdlet is available only in Security & Compliance Center PowerShell. For more information, see Security & Compliance Center PowerShell.

Use the Remove-LabelPolicies cmdlet to remove sensitivity label policies from your organization.

For information about the parameter sets in the Syntax section below, see Exchange cmdlet syntax.

Syntax

Remove-LabelPolicy
      [-Identity] <PolicyIdParameter>
      [-Confirm]
      [-WhatIf]
      [<CommonParameters>]

Description

You need to be assigned permissions in the Security & Compliance Center before you can use this cmdlet. For more information, see Permissions in the Security & Compliance Center.

Examples

Example 1

Remove-LabelPolicy -Identity "Marketing Group"

This example removes the policy named Marketing Group.

Parameters

-Confirm

The Confirm switch specifies whether to show or hide the confirmation prompt. How this switch affects the cmdlet depends on if the cmdlet requires confirmation before proceeding.

  • Destructive cmdlets (for example, Remove-* cmdlets) have a built-in pause that forces you to acknowledge the command before proceeding. For these cmdlets, you can skip the confirmation prompt by using this exact syntax: -Confirm:$false.
  • Most other cmdlets (for example, New-* and Set-* cmdlets) don't have a built-in pause. For these cmdlets, specifying the Confirm switch without a value introduces a pause that forces you acknowledge the command before proceeding.
Type:SwitchParameter
Aliases:cf
Position:Named
Default value:None
Accept pipeline input:False
Accept wildcard characters:False
Applies to:Security & Compliance Center
-Identity

The Identity parameter specifies the policy that you want to remove. You can use any value that uniquely identifies the policy. For example:

  • Name
  • Distinguished name (DN)
  • GUID
Type:PolicyIdParameter
Position:1
Default value:None
Accept pipeline input:True
Accept wildcard characters:False
Applies to:Security & Compliance Center
-WhatIf

The WhatIf switch doesn't work in Security & Compliance Center PowerShell.

Type:SwitchParameter
Aliases:wi
Position:Named
Default value:None
Accept pipeline input:False
Accept wildcard characters:False
Applies to:Security & Compliance Center

Inputs

Outputs