Configure Exchange 2010 protection


Updated: May 13, 2016

Applies To: System Center 2012 SP1 - Data Protection Manager, System Center 2012 - Data Protection Manager, System Center 2012 R2 Data Protection Manager

DPM can back up Exchange 2010. You can back up Exchange data, and the Exchange server with a bare metal backup.

Before you start

Read through the Prerequisites before you set up protection.

Set up protection

  1. Deploy DPM—Verify that DPM is installed and deployed correctly. If it isn’t read:

  2. Set up storage—Check that you have storage set up. Read more about your options in:

  3. Set up the DPM protection agent—The agent needs to be installed on the Exchange server. Read Plan for protection agent deployment, and then Set up the protection agent.

  4. Set up a protection group—In the Select Group Members page of the Create New Protection Group wizard. You select all the DAGs that store data you want to protect. For each Exchange server you can also select to do a system state backup or full bare metal backup (which includes the system state. This in useful if you want the ability to recover your entire server and not just data.Read about protection groups and bare metal backup in:

  5. After you create the protection group initial replication of the data occurs. Backup then takes place in line with the protection group settings.

Set up monitoring

After the protection group’s been created the initial replication occurs and DPM starts backing up and synchronizing the Exchange data. DPM monitors the initial synchronization and subsequent backups. You can monitor the Exchange data in a couple of ways:

  • Using default DPM monitoring can set up notifications for proactive monitoring. by publishing alerts and configuring notifications. You can send notifications by e-mail for critical, warning, or informational alerts, and for the status of instantiated recoveries.

  • If you use Operations Manager you can centrally publish alerts.

Set up monitoring notifications

  1. In the DPM Administrator Console, click Monitoring > Action > Options.

  2. Click SMTP Server, type the server name, port, and email address from which notifications will be sent. The address must be valid.

  3. In Authenticated SMTP server , type a user name and password.The user name and password must be the domain account name of the person whose “From” address is described in the previous step; otherwise, notification delivery fails.

  4. To test the SMTP server settings, click Send Test E-mail, type the e-mail address where you want DPM to send the test message, and then click OK. Click Options > Notifications and select the types of alerts about which recipients want to be notified. In Recipients type the e-mail address for each recipient to whom you want DPM to send copies of the notifications.

  5. To test the SMTP server settings, click Send Test Notification > OK.

Publish alerts for Operations Manager

  1. In the DPM Administrator Console, click Monitoring > Action > Options.

  2. In Options click Alert Publishing > Publish Active Alerts.

  3. After you enable Alert Publishing all existing DPM alerts that might require a user action are published to the DPM Alerts event log. The Operations Manager agent that is installed on the DPM server then publishes these alerts to the Operations Manager and continues to update the console as new alerts are generated.