This test verifies that the touchpad reports a straight line (that corresponds to contact movement) when two contacts that are 14mm apart are moved diagonally across the surface of a touchpad (within a tolerance of .5mm).

Test details

Associated requirements

Device.Input.PrecisionTouchpad.Precision.DiagonalInputSeparation Device.Input.PrecisionTouchpad.Precision.Linearity Device.Input.PrecisionTouchpad.Precision.MotionJitter System.Client.PrecisionTouchpad.PrecisionTouchpad

See the system hardware requirements.


Windows RT 8.1 Windows 8.1 x64 Windows 8.1 x86

Expected run time

~2 minutes





Running the test

Before you run the test, complete the test setup as described in the test requirements: Mouse or other Pointing Device Testing Prerequisites.

This test requires very precise movement in a straight line. We recommend that you perform this test by using a precision rig or other precision device that is capable of straight line movement without any jitter.

  1. Place two precision contacts 14mm apart slightly outside the top left corner of the touchpad.

  2. Drag the contacts in a straight line from the top left to the bottom right corner of the touchpad.

  3. Drag the contacts back from the bottom right up to the top left.

  4. Repeat this pattern for a total of five iterations.


For troubleshooting information, see Troubleshooting Device.Input Testing.

Error Description/Workaround

[15] contact didn’t move in straight line

Reported path strayed varied from a straight line by more than the allowed tolerance.

[14] packet too far from edge: ###

  • Swipe must start at or before the edge.

  • Swipe must go all the way to the opposite edge. Performing swipe too quickly might not allow the device to fully report.

More information

Command syntax

Command Description

ptlogo.exe Test.LinearityDiagonalMultiple.json

Runs the test.

File list

File Location







Send comments about this topic to Microsoft