Test.DeviceBezel

This test verifies that the bezel around the touchpad meets the requirements.

Test details

Associated requirements

Device.Input.PrecisionTouchpad.Hardware.Bezel System.Client.PrecisionTouchpad.PrecisionTouchpad

See the system hardware requirements.

Platforms

Windows RT 8.1 Windows 8.1 x64 Windows 8.1 x86

Expected run time

~2 minutes

Categories

Certification

Type

Manual

 

Running the test

Before you run the test, complete the test setup as described in the test requirements: Mouse or other Pointing Device Testing Prerequisites.

  1. If the touchpad surface is at all above the surrounding casing of the touchpad, press F fail the test. Else, move to the next step.

  2. Place a 1.5mm wide piece of plastic (or other non-conductive material) on the surface of the touchpad, such that the plastic does not touch the surrounding casing of the touchpad.

    • If the touchpad and the plastic is lower than the surrounding casing, press F to fail the test. If the touchpad surface is anywhere, press P to pass.

Troubleshooting

For troubleshooting information, see Troubleshooting Device.Input Testing.

More information

Command syntax

Command Description

ptlogo.exe Test.DeviceBezel.json

Runs the test.

 

File list

File Location

ptlogo.exe

<testbinroot>\input\PrecisionTouchpad\

config.json

<testbinroot>\input\PrecisionTouchpad\

Test.DeviceBezel.json

<testbinroot>\input\PrecisionTouchpad\

 

 

 

Send comments about this topic to Microsoft