Configure an ISDN Adapter for a Dial-up Connection

Applies To: Windows Server 2008

You can use this procedure to configure your Integrated Services Digital Network (ISDN) network adapter for use by your dial-up network connection.

Membership in the local Administrators group, or equivalent, is the minimum required to complete this procedure.

To configure ISDN settings

  1. Click Start, and then click Control Panel.

  2. Do one of the following:

    • If you use the Control Panel Home view, under the Network and Internet section, click View network status and tasks.

    • If you use the Classic View, double-click Network and Sharing Center.

  3. In the Tasks pane, click Manage network connections.

  4. Right-click the dial-up connection that uses ISDN, and then click Properties.

  5. On the General tab, in Connect using, select the ISDN device, and then click Configure.

  6. In the ISDN Configure dialog box, do one or both of the following:

    • In Line type, click the line type you want to use. The line types are listed from highest to lowest quality.

    • If you want to start negotiation with the line type you selected, and then negotiate with a lower-quality line type depending on the line's condition, select the Negotiate line type check box.

Additional considerations

  • Depending on the type of ISDN adapter that you are using, when you click Configure in stepĀ 3, you might be presented with Modem Configuration settings.