Event ID 20229 — RRAS NAP and Network Access Quarantine Control
Applies To: Windows Server 2008 R2
Network Access Protection (NAP) provides a platform to help ensure that client computers on a private network meet administrator-defined requirements for system health. NAP enforcement occurs at the moment client computers attempt to access the network through network access servers, such as a virtual private network (VPN) server running Routing and Remote Access, or when client computers attempt to communicate with other network resources.
Network Access Quarantine Control is similar in function to NAP VPN enforcement, but it provides added protection for remote access connections only. NAP provides added protection for Internet Protocol security (IPsec)-based communications, 802.1X authenticated connections, VPN connections, Dynamic Host Configuration Protocol (DHCP) configuration, and Terminal Services Gateway (TS Gateway) connections.
|Product:||Windows Operating System|
|Message:||The remote access connection with the correlation ID %1 received an unexpected/mismatched response to its Statement of Health (SoH) from the server. The NAP correlation ID for this transaction is %2.|
Routing and Remote Access service will wait for another response
No user action is required. The Routing and Remote Access service will wait for another response.
To verify that NAP remote access enforcement clients are installed and initialized:
- On the NAP client computer, click Start, point to All Programs, click Accessories, and then click Command Prompt.
- In the command window, type netsh nap client show configuration, and then press ENTER.
- If the client computer's NAP configuration is determined by Group Policy, type netsh nap client show grouppolicy, and then press ENTER.
- In the command output, under Enforcement clients, verify that the enforcement clients listed for your deployment are correct, and that the enforcement clients in use on your network have an Admin value of Enabled.
- In the command window, type netsh nap client show state, and then press ENTER.
- In the command output, under Enforcement client state, verify that all enforcement clients listed for your deployment are correct, and that the enforcement clients that are enabled on the client computer have an Initialized value of Yes.