Event ID 17 — RRAS Secure Socket Tunneling Protocol
Applies To: Windows Server 2008 R2
Secure Socket Tunneling Protocol (SSTP) is a new form of virtual private networking (VPN) tunnel with features that allow traffic to pass through firewalls that block PPTP and L2TP/IPsec traffic. SSTP provides a mechanism to encapsulate Point-to-Point (PPP) traffic over the Secure Sockets Layer (SSL) channel of the HTTPS protocol. The use of HTTPS means traffic will flow through TCP port 443, a port commonly used for Web access.
|Product:||Windows Operating System|
|Message:||The Secure Socket Tunneling Protocol service could not open the Parameters section of the registry to read the configuration values, so SSTP cannot be initialized. The detailed error message is provided below. Correct the problem and try again.
Provide the permission for SSTP relevant registry parameter
Open the Registry Editor and check the values of the following registry key:
Check that the System account has read/write permission for each registry key. To check the permissions:
- Right-click each registry key, and then click Permissions.
- If the System account does not have read/write permissions for the key, add them.
To verify that the remote access server can accept connections, establish a remote access connection from a client computer.
To create a VPN connection:
- Click Start, and then click Control Panel.
- Click Network and Internet, click Network and Sharing Center, and then click Set up a connection or network.
- Click Connect to a workplace, and then click Next.
- Complete the steps in the Connect to a Workplace wizard.
To connect to a remote access server:
- In Network and Sharing Center, click Manage network connections.
- Double-click the VPN connection, and then click Connect.
- Verify that the connection was established successfully.