Event ID 11158 — DNS Client Registration
Applies To: Windows Server 2008 R2
A computer that is configured to use Dynamic Host Configuration Protocol (DHCP) to obtain IP addresses can automatically register its IP address and Domain Name System (DNS) name with the DNS server that is authoritative for the zone that hosts its domain. This eliminates the need for an administrator to manage host (A or AAAA) resource records for client computers. Problems with automatic registration do not prevent a computer from accessing the network, but they can prevent other network computers from being able to locate the computer.
|Product:||Windows Operating System|
|Message:||The system failed to register pointer (PTR) resource records for the network adapter with these settings:
Adapter Name : %1
Host Name: %2
Adapter-specific Domain Suffix: %3
DNS server list:
Sent update to server: %5
IP Address: %6
Either the DNS server does not support the DNS dynamic update protocol, or the authoritative zone where these records are to be registered does not allow dynamic updates.
To add or register DNS PTR resource records using the specific DNS domain name and IP address for this adapter, contact your network administrator.
Contact your network administrator
To resolve this problem, contact your network administrator, and provide the information in the event message.
If you are a network administrator, see Troubleshooting Dynamic Updates (http://go.microsoft.com/fwlink/?LinkId=103842) for information about troubleshooting DNS registration.
Use the ipconfig /registerdns command to register the computer's network name and address with a DNS server and then check the event log for errors.
To perform this procedure, you must have membership in Administrators, or you must have been delegated the appropriate authority.
To register the computer's network name and address with a DNS server:
On the DNS client, open a command prompt. To open an elevated Command Prompt window, click Start, point to All Programs, click Accessories, right-click Command Prompt, and then click Run as administrator.
Type the following command, and then press ENTER:
Wait 15 minutes, and then check the event log to verify that a DNSapi event with an ID in the range 11150 through 11167 was not logged after you ran the command.