Migrate POP3 connectors

Applies To: Windows SBS 2008

Note

This is an optional step. If you did not configure the POP3 connectors on the Source Server, skip this step.

To remove POP3 connectors from the Source Server

  1. On the Source Server, open the Windows SBS Console.

  2. In the navigation bar, click the Network tab, and then click Connectivity.

  3. Right-click POP3 Connector, and then click View POP3 Connector properties.

  4. Click each user account, click Edit, and then write down the POP3 Mailbox to Exchange settings.

Note

Global mailboxes are not supported in Windows SBS 2008. Instead, you can map a POP3 account to an e-mail enabled group in Windows SBS 2008.

  1. Remove each user account that is listed, and then click OK.

To add POP3 connectors in Windows Small Business Server 2008

  1. On the Destination Server, open the Windows SBS Console.

  2. On the navigation bar, click the Network tab, and then click Connectivity.

  3. Right-click POP3 Connector, and then click View POP3 Connector properties.

  4. On the Mail Accounts tab, click Add, and then add each of the accounts that were on the Source Server.

  5. When you finish adding the POP3 mailboxes, click OK.