IOCTL_USBPRINT_GET_1284_ID IOCTL (usbprint.h)
The IOCTL_USBPRINT_GET_1284_ID control code allows upper-layer software (such as a language monitor), to request and obtain the printer's IEEE 1284 device ID string.
Major code
Input buffer
Not used in this operation; set this parameter to NULL.
Input buffer length
Not used in this operation; set this parameter to 0.
Output buffer
The output buffer will contain UCHAR data. On success this buffer can hold the following: a two-byte prefix that specifies the size, in bytes, of the device's IEEE 1284 device ID; the device ID; and a null terminator. An IEEE 1284 device ID can be up to 64 KB in size. On failure, if GetLastError returns the error code STATUS_BUFFER_TOO_SMALL, the output buffer was not large enough to hold the data intended for it.
Output buffer length
The output buffer must be large enough to contain a two-byte quantity holding the length of the device's IEEE 1284 device ID, the device ID (up to 64 KB in size), and a terminating null.
The IOCTL_USBPRINT_GET_1284_ID output buffer length is placed directly into the USB packet. On some USB print devices, using the maximum 65535 bytes can cause the call to fail with error 23. Reduce the buffer to 4094 bytes or less to resolve this issue.
Status block
Irp->IoStatus.Status is set to STATUS_SUCCESS if the request is successful. Otherwise, Status to the appropriate error condition as a NTSTATUS code.
Requirements
| Requirement | Value |
|---|---|
| Header | usbprint.h |
See also
Creating IOCTL Requests in Drivers
WdfIoTargetSendInternalIoctlOthersSynchronously
Feedback
Coming soon: Throughout 2024 we will be phasing out GitHub Issues as the feedback mechanism for content and replacing it with a new feedback system. For more information see: https://aka.ms/ContentUserFeedback.
Submit and view feedback for