tt (Trace to Next Return)

The tt command executes the program until a return instruction is reached.


[~Thread] tt [r] [= StartAddress] [Count] 


tt [r] [= StartAddress] [Count] 


Specifies threads to continue executing. All other threads are frozen. For more information about the syntax, see Thread Syntax. You can specify threads only in user mode.

Turns on and off the display of registers and flags. By default, the registers and flags are displayed. You can disable register display by using the ttr, pr, tr, or .prompt_allow -reg commands. All of these commands control the same setting and you can use any of them to override any previous use of these commands.

You can also disable register display by using the l-os command. This setting is separate from the other four commands. To control which registers and flags are displayed, use the rm (Register Mask) command.

Specifies the address where the debugger begins execution. If you do not use StartAddress, execution begins at the instruction that the instruction pointer points to. For more information about the syntax, see Address and Address Range Syntax.

Specifies the number of return instructions that the debugger must encounter for the th command to end. The default value is one.



User mode, kernel mode


Live debugging only



Additional Information

For more information about related commands, see Controlling the Target.


The tt command causes the target to begin executing. This execution continues until the debugger reaches a return instruction or encounters a breakpoint

If the program counter is already on a return instruction, the debugger traces into the return and continues executing until another return is reached. This tracing, rather than execution, of the call is the only difference between tt and pt (Step to Next Return).

In source mode, you can associate one source line with multiple assembly instructions. This command does not stop at a return instruction that is associated with the current source line.