正在验证缩放单位节点磁盘运行状况Verifying Scale Unit node disk health

  1. 连接到特权终结点 (PEP)。Connect to the privileged endpoint (PEP).

    1. 有关连接到 PEP 的说明,请参阅特权访问工作站和特权终结点访问。See Privileged Access Workstation and privileged endpoint access for instructions for connecting to the PEP.

    2. 连接后,输入 PEP 会话, Enter-PSSession -Session $pepOnce connected, enter the PEP session, Enter-PSSession -Session $pep.

  2. 获取虚拟磁盘运行状况。Get the virtual disk health.

    1. 运行 Get-VirtualDisk -cimsession "S-Cluster" 验证虚拟磁盘运行状况。Run Get-VirtualDisk -cimsession "S-Cluster" to verify virtual disk health.

      如果系统未返回 "正常" 和 " 正常" HealthStatusOperationalStatus ,请等待几分钟,然后再次运行该命令。If the system does not return an OperationalStatus of OK and a HealthStatus of Healthy, then wait a few minutes and then run the command again.

      显示 Windows PowerShell 的屏幕截图,其中突出显示了 "OperationsStatus" 和 "HealthStatus" 列。

    2. 运行 Get-VirtualDisk -cimsession "S-Cluster" | Get-StorageJob 验证所有正在运行的存储作业是否已完成。Run Get-VirtualDisk -cimsession "S-Cluster" | Get-StorageJob to verify that all running storage jobs are complete.

    3. 验证是否未返回任何结果。Verify that no results are returned. 如果作业仍在运行,如 JobState 所示,或所有作业标记为已完成,则等待另外10分钟,然后再次运行相同的命令。If there are jobs still running, as shown by JobState, or all the jobs are marked as complete, then wait another 10 minutes and run the same command again. 最终状态应为 "未列出任何作业"。The final state should be that no jobs are listed.

    4. 如果需要,可以在 使用 Azure Stack 中心 PowerShell 检查虚拟磁盘修复的状态中找到其他存储健康验证步骤。If needed, additional storage health verification steps can be found in the Check the status of virtual disk repair using Azure Stack Hub PowerShell.