如何升級 Web 主控台How to upgrade a Web console

開始執行升級程序之前,請確定您的伺服器符合最低的 System Center Operations Manager 支援設定。Before you begin the upgrade process, make sure that your server meets the minimum supported configurations for System Center Operations Manager. 此程序不適用於 1801 版。This process is not applicable for version 1801. 如需詳細資訊,請參閱 System Center Operations Manager 的系統需求For more information, see System Requirements for System Center Operations Manager.

注意

當您升級 Web 主控台時,在安裝 Web 主控台後對 web.config 檔案進行的任何自訂都將重設。When you upgrade the web console, any customizations that were made to the web.config file after the web console was installed will be reset. 製作備份後再繼續。Make a backup copy before proceeding.

如果您在設定 Web 主控台後進行變更以啟用或停用安全通訊端層 (SSL),SSL 設定將會在升級期間重設。If you made changes after you set up your web console to either enable or disable Secure Sockets Layer (SSL), the SSL settings will be reset during upgrade. 若要解決此問題,您必須在升級 Web 主控台之前對登錄機碼進行變更,如下所示:To resolve the issue, you must make changes to the registry key before you upgrade the web console, as follows:

設定登錄以在 Web 主控台上啟用或停用 SSLTo set the registry to enable or disable SSL on the Web console server

  1. 使用具有本機系統管理員權限的帳戶登入 Web 主控台,然後在桌面上按一下 [開始] ,再按一下 [執行] 。Logon on to the web console with an account that has local administrator rights, and on the desktop, click Start, and then click Run.

  2. 輸入 regedit,然後按一下 [確定] 。Type regedit, and then click OK. 登錄編輯程式隨即啟動。The Registry Editor starts.

    警告

    不當編輯登錄可能會對系統造成嚴重損害。Incorrectly editing the registry can severely damage your system. 在變更登錄前,您應先備份電腦上任何重要的資料。Before you make changes to the registry, you should back up any valued data that is on the computer.

  3. 瀏覽至 HKey_Local_Machine\Software\Microsoft\System Center Operations Manager\12\Setup\WebConsole\ 機碼。Navigate to the HKey_Local_Machine\Software\Microsoft\System Center Operations Manager\12\Setup\WebConsole\ key.

  4. 若要啟用 SSL,請設定下列項目:To enable SSL, set the following:

    HTTP_GET_ENABLED=0HTTP_GET_ENABLED=0

    BINDING_CONFIGURATION=DefaultHttpsBindingBINDING_CONFIGURATION=DefaultHttpsBinding

  5. 若要停用 SSL,請設定下列項目:To disable SSL, set the following:

    HTTP_GET_ENABLED=1HTTP_GET_ENABLED=1

    BINDING_CONFIGURATION=DefaultHttpBindingBINDING_CONFIGURATION=DefaultHttpBinding

升級 Web 主控台伺服器To upgrade the Web console server

  1. 使用 Operations Manager 管理群組中屬於 Operations Manager 系統管理員角色的帳戶登入裝載 Web 主控台伺服器的電腦。Log on to the computer that hosts the web console server with an Operations Manager Administrators role account for your Operations Manager management group.

  2. 在 Operations Manager 來源媒體上執行 Setup.exe,然後按一下 [安裝] 。On the Operations Manager source media, run Setup.exe, and then click Install.

    注意

    [開始使用] 頁面隨即顯示升級項目的相關資訊。The Getting Started page displays information about what will be upgraded. 按 [下一步] ,繼續進行升級作業。Click Next to proceed with the upgrade.

  3. 在 [使用入門] 的 [請閱讀授權條款] 頁面上,閱讀 Microsoft 軟體授權條款、按一下 [我已閱讀、瞭解並同意授權條款] ,然後按一下 [下一步] 。On the Getting Started, Please read the license terms page, read the Microsoft Software License Terms, click I have read, understood, and agree with the license terms, and then click Next.

  4. 在 [選取安裝位置] 頁面上,接受預設值、鍵入新位置或瀏覽至某個位置。On the Select installation location page, accept the default value, type in a new location, or browse to one. 然後按 [下一步] 。Then click Next.

    注意

    針對 System Center 2016 - Operations Manager,預設的安裝路徑為 C:\Program Files\Microsoft System Center 2016\Operations Manager。For System Center 2016 - Operations Manager, the default path is C:\Program Files\Microsoft System Center 2016\Operations Manager. 針對所有更新版本 (1801、1807 和 2019),預設路徑為 C:\Program Files\Microsoft System Center\Operations Manager。For all later releases (1801, 1807 and 2019), the default path is C:\Program Files\Microsoft System Center\Operations Manager.

  5. 在 [必要條件] 頁面上,檢閱並解決必要條件檢查程式傳回的任何警告或錯誤,然後按一下 [再次驗證必要條件] 來重新檢查系統。On the Prerequisites page, review and address any warnings or errors that the Prerequisites checker returns, and then click Verify Prerequisites Again to recheck the system.

  6. 如果必要條件檢查程式未傳回任何警告或錯誤,[必要條件] 的 [繼續安裝] 頁面隨即出現。If the Prerequisites checker does not return any warnings or errors, the Prerequisites, Proceed with Setup page appears. 按一下 [下一步]Click Next.

  7. 當 [準備升級] 頁面出現時,請檢閱升級摘要,然後按一下 [升級] 。When the Ready to Upgrade page appears, review the upgrade summary, and then click Upgrade.

從命令提示字元升級 Web 主控台伺服器To upgrade the Web console server from the Command Prompt

  1. 使用 Operations Manager 管理群組中屬於 Operations Manager 系統管理員角色的帳戶登入裝載 Web 主控台伺服器的電腦。Log on to the computer that hosts the web console server with an Operations Manager Administrators role account for your Operations Manager management group.

  2. 使用 [以系統管理員身分執行] 選項開啟 [命令提示字元]。Open a Command Prompt by using the Run as Administrator option.

  3. 將路徑變更為 Operations Manager Setup.exe 檔案所在的位置,然後執行下列命令。Change the path to where the Operations Manager Setup.exe file is located, and run the following command.

    重要

    只有在網站啟用安全通訊端層 (SSL) 的情況下才使用 /WebConsoleUseSSL 參數。Use the /WebConsoleUseSSL parameter only if your website has Secure Sockets Layer (SSL) activated. 若為預設網站安裝,請在 參數指定 Default Web Site /WebSiteNameFor a default web installation, specify Default Web Site for the /WebSiteName parameter.

    setup.exe /silent /AcceptEndUserLicenseAgreement:1 /upgrade
    /WebsiteName: "<WebSiteName>" [/WebConsoleUseSSL]
    /WebConsoleAuthorizationMode: [Mixed|Network]
    

後續步驟Next steps