Enable-ComplianceTagStorage

This cmdlet is available only in the Office 365 Security & Compliance Center. For more information, see Office 365 Security & Compliance Center PowerShell (https://technet.microsoft.com/library/mt587091.aspx). Use the Enable-ComplianceTagStorage cmdlet to create the label policy in the Security & Compliance Center. This is a one-time operation. Labels apply retention settings to content. For information about the parameter sets in the Syntax section below, see Exchange cmdlet syntax (https://technet.microsoft.com/library/bb123552.aspx).

Syntax

Enable-ComplianceTagStorage
      [-Confirm]
      [-WhatIf]
      [<CommonParameters>]

Description

If you run this cmdlet more than once, you'll get an error that says a policy already exists.

You need to be assigned permissions in the Office 365 Security & Compliance Center before you can use this cmdlet. For more information, see Permissions in Office 365 Security & Compliance Center (https://go.microsoft.com/fwlink/p/?LinkId=511920).

Examples

-------------------------- Example 1 --------------------------

Enable-ComplianceTagStorage

This example creates the label policy in the Security & Compliance Center.

Optional Parameters

-Confirm

The Confirm switch specifies whether to show or hide the confirmation prompt. How this switch affects the cmdlet depends on if the cmdlet requires confirmation before proceeding.

  • Destructive cmdlets (for example, Remove-* cmdlets) have a built-in pause that forces you to acknowledge the command before proceeding. For these cmdlets, you can skip the confirmation prompt by using this exact syntax: -Confirm:$false.

  • Most other cmdlets (for example, New-* and Set-* cmdlets) don't have a built-in pause. For these cmdlets, specifying the Confirm switch without a value introduces a pause that forces you acknowledge the command before proceeding.

Type:SwitchParameter
Aliases:cf
Position:Named
Default value:None
Accept pipeline input:False
Accept wildcard characters:False
Applies to:Office 365 Security & Compliance Center
-WhatIf

The WhatIf switch doesn't work in the Office 365 Security & Compliance Center.

Type:SwitchParameter
Aliases:wi
Position:Named
Default value:None
Accept pipeline input:False
Accept wildcard characters:False
Applies to:Office 365 Security & Compliance Center

Inputs

To see the input types that this cmdlet accepts, see Cmdlet Input and Output Types (https://go.microsoft.com/fwlink/p/?linkId=616387). If the Input Type field for a cmdlet is blank, the cmdlet doesn't accept input data.

Outputs

To see the return types, which are also known as output types, that this cmdlet accepts, see Cmdlet Input and Output Types (https://go.microsoft.com/fwlink/p/?linkId=616387). If the Output Type field is blank, the cmdlet doesn't return data.