Share via


WCMP_PROVIDER_SPECIFIC_DATA

A version of this page is also available for

Windows Embedded CE 6.0 R3

4/8/2010

This structure is used for provider-specific data for use with SmsSendMessage and SmsReadMessage calls. Supporting Global System for Mobile Communications (GSM) Wireless Control Message Protocol (WCMP) is required for compliance as an Short Message Service (SMS) bearer.

Syntax

typedef struct wcmp_provider_specific_data_tag {
    WCMP_PROVIDER_SPECIFIC_MESSAGE_TYPE wcmppsMessageType;
    WORD wParam1;
    WORD wParam2;
    WORD wParam3;
    SMS_ADDRESS smsaAddress;
} WCMP_PROVIDER_SPECIFIC_DATA;

Members

  • wcmppsMessageType
    The type of WCMP message.
  • wParam1, wParam2, wParam3, smsaAddress
    Use of these parameters is shown in the following table. The WCMP type and code are shown for reference only.

    DwMessageType wParam1 WParam2 wParam3 smsaAddress

    WCMP_PORT_UNREACHABLE

    Destination port of original packet

    Source port of original packet

    Ignored

    Destination address of original packet

    WCMP_MESSAGE_TOO_BIG

    Destination port of original packet

    Source port of original packet

    Maximum message size in bytes

    Destination address of original packet

    WCMP_ECHO_REQUEST

    Identifier

    Sequence number

    Ignored

    Ignored

    WCMP_ECHO_REPLY

    Identifier

    Sequence number

    Ignored

    Ignored

Remarks

The WDP layer sends the WCMP_MESSAGETOOBIG message if an incoming primitive exceeds its limit. However, the WDP Short Message Service (SMS) provider will also issue this WCMP message directly if a multipart message is bigger than the provider can handle.

Also note that the WDP layer, not the GSM WCMP provider, sends replies to WCMP_ECHOREQUEST messages.

Requirements

Header sms.h
Windows Embedded CE Windows Embedded CE 6.0 and later
Windows Mobile Pocket PC 2002 and later, Smartphone 2002 and later

See Also

Reference

Short Message Service Structures
SmsSendMessage
SmsReadMessage