Recover a Database Availability Group Member Server
Applies to: Exchange Server 2010
If a Mailbox server that's a member of a database availability group (DAG) is lost or otherwise fails and is unrecoverable and needs replacement, you can perform a server recovery operation. Microsoft Exchange Server 2010 Setup includes the switch /m:RecoverServer that can be used to perform the server recovery operation. Running Setup with the /m:RecoverServer switch causes Setup to read the server's configuration information from Active Directory for a server with the same name as the server from which you're running Setup. After the server's configuration information is gathered from Active Directory, the original Exchange files and services are then installed on the server, and the roles and settings that were stored in Active Directory are then applied to the server.
Looking for other management tasks related to DAGs? Check out Managing Database Availability Groups.
Use Setup /m:RecoverServer to recover a server
You need to be assigned permissions before you can perform this procedure. To see what permissions you need, see the"Mailbox database copies" entry in the High Availability Permissions topic.
Retrieve any replay lag or truncation lag settings for any mailbox database copies that exist on the server being recovered by using the Get-MailboxDatabase cmdlet.
Get-MailboxDatabase DB1 | Format-List *lag*
Remove any mailbox database copies that exist on the server being recovered by using the Remove-MailboxDatabaseCopy cmdlet.
Remove the failed server's configuration from the DAG by using the Remove-DatabaseAvailabilityGroupServer cmdlet.
Remove-DatabaseAvailabilityGroupServer -Identity DAG1 -MailboxServer MBX1
Reset the server's computer account in Active Directory. For detailed steps, see Reset a Computer Account.
Open a Command Prompt window. Using the original Setup media, run the following command.
When the Setup recovery process is complete, add the recovered server to the DAG by using the Add-DatabaseAvailabilityGroupServer cmdlet.
Add-DatabaseAvailabilityGroupServer -Identity DAG1 -MailboxServer MBX1
After the server has been added back to the DAG, you can reconfigure mailbox database copies by using the Add-MailboxDatabaseCopy cmdlet. If any of the database copies being added previously had replay lag or truncation lag times greater than 0, you can use the ReplayLagTime and TruncationLagTime parameters of the Add-MailboxDatabaseCopy cmdlet to reconfigure those settings.
Add-MailboxDatabaseCopy -Identity DB1 -MailboxServer MBX1 Add-MailboxDatabaseCopy -Identity DB2 -MailboxServer MBX1 -ReplayLagTime 3.00:00:00 Add-MailboxDatabaseCopy -Identity DB3 -MailboxServer MBX1 -ReplayLagTime 3.00:00:00 -TruncationLagTime 3.00:00:00