Input - Touch Tests (Compact 7)

Article
03/14/2014

3/12/2014

The Input - Touch tests are comprised of the following.

In This Section

Test	Introduction
Calibration Abort Test	Tests the TouchPanelReadCalibrationAbort function, which aborts a TouchPanelReadCalibrationPointfunction call
Calibration Test	Calibrates the touch panel if it is not already calibrated, and then calls the TouchPanelCalibrateAPoint function with a range of point values to verify success
Device Power State Test	Tests the behavior when the touch driver is deactivated through the touch panel’s parent bus driver
Drawing Test	Tests the ability of the touch panel driver to properly detect tap and release events on the touch panel
Null Parameter Test	Null parameter test
Pen Up and Down Test	Tests the ability of the touch panel driver to properly detect tap and release events on the touch panel
Point Test	Tests the ability of the touch driver to correctly detect pen coordinates on the touch panel
Power Capabilities Test	Verifies whether the D0 and D3 power states are supported by the touch driver
Query Device Caps Test	Tests the TouchPanelGetDeviceCaps function, if the function is supported by the touch panel driver
Read Calibration Point Test	Tests the TouchPanelReadCalibrationPoint function, which reads a single point of data from the touch panel
Set Sample Rate Test	Tests the TouchPanelSetMode function, if the function is supported by the touch-panel driver
Touch BVT Test	Verifies whether the touch driver is loaded and registered correctly in the registry
Touch Driver Unloaded Test	Tests the behavior when the touch driver is deactivated through the touch panel’s parent bus driver
Touch Panel APIs, Functional, Power Management, and Fault Injection Tests	Performs API, functional, power management, and fault injection tests

See Also

Reference

Other Resources

Compact Test Kit (CTK)