Event ID 20114 — RRAS Other Remote Access Server Configurations
Applies To: Windows Server 2008 R2
Successful remote access and routing connections require the correct configuration of firewall settings and IP routing protocols.
|Product:||Windows Operating System|
|Message:||The remote access server will not accept calls. No protocols were configured for use.|
Configure a routing protocol
To perform this procedure, you must have membership in Administrators, or you must have been delegated the appropriate authority.
To add an IP routing protocol:
- Open Routing and Remote Access. Click Start, click Run, type rrasmgmt.msc, and then press ENTER.
- In the console tree, double-click the server name.
- Double-click IPv4 or IPv6, right-click General, and then click New Routing Protocol.
- In Routing protocols, click the protocol you want to add, and then click OK.
- Complete the fields in the configuration dialog boxes, if required for the protocol.
To verify that the remote access server can accept connections, establish a remote access connection from a client computer.
To create a VPN connection:
- Click Start, and then click Control Panel.
- Click Network and Internet, click Network and Sharing Center, and then click Set up a connection or network.
- Click Connect to a workplace, and then click Next.
- Complete the steps in the Connect to a Workplace wizard.
To connect to a remote access server:
- In Network and Sharing Center, click Manage network connections.
- Double-click the VPN connection, and then click Connect.
- Verify that the connection was established successfully.