Event ID 108 — NLB Host Configuration
Updated: November 25, 2009
Applies To: Windows Server 2008 R2
Hosts in a Network Load Balancing (NLB) cluster are configured to load balance network traffic. Host configuration is set by using NLB Manager, and if it is not configured properly, the NLB cluster may not function correctly.
|Product:||Windows Operating System|
|Message:||NLB cluster [%2]: The virtual IP (VIP) address %3 is invalid. The cluster will converge and operate normally without this VIP. Make sure that the VIP is specified in a valid IPv4 or IPv6 address format.|
Check that the virtual IP address is valid
The virtual IP address must be in a valid IPv4 or IPv6 format.
When you are using Network Load Balancing (NLB) Manager, you must be a member of the Administrators group on the host that you are configuring, or you must have been delegated the appropriate authority. If you are configuring a cluster or host by running NLB Manager from a computer that is not part of the cluster, you do not have to be a member of the Administrators group on that computer.
To check that the virtual IP address is in a valid IPv4 or IPv6 format:
- Click Start, click Administrative Tools, and then click Network Load Balancing Manager. You can also open NLB Manager by typing Nlbmgr at a command prompt.
- If NLB Manager does not already list the cluster, connect to the cluster.
- Right-click the cluster, and then click Cluster Properties.
- In IP address, verify that the IPv4 or IPv6 address is correctly formatted. IPv4 addresses use the standard Internet dotted notation (for example, w.x.y.z). IPv6 addresses use 16-byte addresses, typically expressed in colon-hexadecimal notation. Colon-hexadecimal notation uses eight 4-digit hexadecimal numbers, with colons separating the 16-bit blocks (the 4-digit numbers). To manage addresses more easily, IPv6 suppresses leading zeros and compresses a single contiguous all-zero 16-bit block, represent the contiguous block with two colons (::). This is known as double-colon compression. An example of an IPv6 address with leading zeros suppressed is: FEC0:0:0:0:2AA:FF:FE3F:2A1C.
When you are using nlb.exe, you must be a member of the Administrators group on the host that you are configuring, or you must have been delegated the appropriate authority. If you are configuring a cluster or host by running nlb.exe from a computer that is not part of the cluster, you do not have to be a member of the Administrators group on that computer.
To verify that all Network Load Balancing (NLB) hosts are in the converged state:
- Open an elevated Command Prompt window. Click Start, point to All Programs, click Accessories, right-click Command Prompt, and then click Run as administrator.
- Type nlb.exe query, which displays the current cluster state and the list of host priorities for the current hosts of the cluster.
- Confirm that all hosts display converged as their current state.