Reporting Device Online Status

The WIA service checks a WIA device's online status by calling the IStiUSD::GetStatus method. The WIA minidriver should check the hardware's current online state and report the results.

The WIA service calls the IStiUSD::GetStatus method for two major operations:

• Checking the device's online status.

• Polling for device events, such as a push button event.

Determining the operation request can be done by checking the StatusMask member of the STI_DEVICE_STATUS structure. The StatusMask member can be either of the following requests.

STI_DEVSTATUS_ONLINE_STATE
Check whether the device is online.

STI_DEVSTATUS_EVENTS_STATE
Check for device events.

STI_DEVSTATUS_ONLINE_STATE

This operation request should be carried out by setting the dwOnlineState member of the STI_DEVICE_STATUS structure.

STI_DEVSTATUS_EVENTS_STATE

This operation request should be carried out by setting the dwEventHandlingState member of the STI_DEVICE_STATUS structure. The value that should be used is STI_EVENTHANDLING_PENDING. (The device has an event pending and is waiting to report it to the WIA service.)

When STI_EVENTHANDLING_PENDING is set, the WIA service is signaled that an event has occurred in the WIA driver. The WIA service calls the IStiUSD::GetNotificationData method to get more information about the event.

The IStiUSD::GetNotificationData method is called for polled events and interrupt events. It is in this method that you should fill out the proper event information to return to the WIA service.

Note   Always clear the STI_EVENTHANDLING_PENDING flag in the dwEventHandlingState member to ensure that it is properly set when a device event occurs.

The following example shows an implementation of the IStiUSD::GetStatus method.

STDMETHODIMP CWIADevice::GetStatus(PSTI_DEVICE_STATUS pDevStatus)
{
  //
  // If the caller did not pass in the correct parameters,
  // then fail the call with E_INVALIDARG.
  //

  if(!pDevStatus)
  {
      return E_INVALIDARG;
  }

  HRESULT hr = S_OK;

  //
  // If we are asked, verify the device is online.
  //

  if (pDevStatus->StatusMask & STI_DEVSTATUS_ONLINE_STATE) {

    //
    // assume the device is OFF-LINE before continuing. This will
    // validate that the online check was successful.
    //

    pDevStatus->dwOnlineState = STI_ONLINESTATE_OFFLINE;

    if(MyDeviceIsOnlineStatus()) {
 
      //
      // device is ON-LINE and operational
      //

      pDevStatus->dwOnlineState |= STI_ONLINESTATE_OPERATIONAL;
    } else {

      //
      // device is OFF-LINE and NOT operational
      //

 }
  }
  return S_OK;
}