Edit

NVME_CONTROLLER_STATUS union (nvme.h)

  • Article

Contains values that indicate controller status.

This structure is used in the CSTS field of the NVME_CONTROLLER_REGISTERS structure.

Syntax

typedef union {
  struct {
    ULONG RDY : 1;
    ULONG CFS : 1;
    ULONG SHST : 2;
    ULONG NSSRO : 1;
    ULONG PP : 1;
    ULONG Reserved0 : 26;
  } DUMMYSTRUCTNAME;
  ULONG  AsUlong;
} NVME_CONTROLLER_STATUS, *PNVME_CONTROLLER_STATUS;

Members

DUMMYSTRUCTNAME

DUMMYSTRUCTNAME.RDY

Indicates whether the controller is ready to accept Submission Queue Tail doorbell writes.

When this value is set to 1, the controller is ready to accept Submission Queue Tail doorbell writes after the EN field in the Controller configuration is set to 1.

This value is cleared to 0 when EN is cleared to 0. Commands cannot be submitted to the controller until this field is set to 1 after EN** is set to 1. Failure to follow this requirement produces undefined results.

Host software must wait at least as long as the Timeout TO value in Controller Capabilities for this field to be set to 1 after EN is set to 1 from a previous value of 0.

DUMMYSTRUCTNAME.CFS

Indicates whether a fatal controller error has occurred.

When this value is set to 1, a fatal controller error occurred that could not be communicated in the appropriate Completion Queue. When this value is cleared to 0, a fatal controller error has not occurred.

The reset value of this field is 1 when a fatal controller error is detected during controller initialization.

DUMMYSTRUCTNAME.SHST

A NVME_CSTS_SHST_SHUTDOWN_STATUS value that indicates the status of shutdown processing. Shutdown processing is initiated by the host setting the SHN field of the Controller configuration.

To start executing commands on the controller after a shutdown operation (indicated when this value is set to NVME_CSTS_SHST_SHUTDOWN_COMPLETED), a Controller Reset, setting the EN field of the Controller configuration to 0, is required. If the host software submits commands to the controller without issuing a reset, the behavior is undefined.

DUMMYSTRUCTNAME.NSSRO

Indicates that the last NVM Subsystem Reset occurred while power was applied to the NVM subsystem.

When this value is set to 1, the last occurrence of an NVM Subsystem Reset occurred while power was applied to the NVM subsystem.

The initial value of this field is 0 following an NVM Subsystem Reset due to application of power to the NVM subsystem. This field is only valid if the controller supports the NVM Subsystem Reset feature, indicated by the NSSRS field of Controller Capabilities being set to 1.

The reset value of this field is 0 if an NVM Subsystem Reset causes activation of a new firmware image.

DUMMYSTRUCTNAME.PP

Indicates whether the controller is processing commands.

When this value is cleared to 0, the controller is processing commands normally. When this value is set to 1, the controller has temporarily stopped processing commands in order to handle an event, such as firmware activation.

This field is only valid when the EN field of the Controller configuration is set to 1.

DUMMYSTRUCTNAME.Reserved0

AsUlong

Requirements

Requirement Value
Minimum supported client Windows 10
Header nvme.h

See also