Enable-ComplianceTagStorage

This cmdlet is available only in Security & Compliance Center PowerShell. For more information, see Security & Compliance Center PowerShell.

Use the Enable-ComplianceTagStorage cmdlet to create the label policy in the Microsoft 365 security center. This is a one-time operation. Labels apply retention settings to content.

For information about the parameter sets in the Syntax section below, see Exchange cmdlet syntax.

Syntax

Enable-ComplianceTagStorage
      [-Confirm]
      [-RecordsManagementSecurityGroupEmail <String>]
      [-WhatIf]
      [<CommonParameters>]

Description

If you run this cmdlet more than once, you'll get an error that says a policy already exists.

To use this cmdlet in Security & Compliance Center PowerShell, you need to be assigned permissions. For more information, see Permissions in the Microsoft 365 compliance center.

Examples

Example 1

Enable-ComplianceTagStorage

This example creates the label policy in the Microsoft 365 compliance center.

Parameters

-Confirm

The Confirm switch specifies whether to show or hide the confirmation prompt. How this switch affects the cmdlet depends on if the cmdlet requires confirmation before proceeding.

  • Destructive cmdlets (for example, Remove-* cmdlets) have a built-in pause that forces you to acknowledge the command before proceeding. For these cmdlets, you can skip the confirmation prompt by using this exact syntax: -Confirm:$false.
  • Most other cmdlets (for example, New-* and Set-* cmdlets) don't have a built-in pause. For these cmdlets, specifying the Confirm switch without a value introduces a pause that forces you acknowledge the command before proceeding.
Type:SwitchParameter
Aliases:cf
Position:Named
Default value:None
Accept pipeline input:False
Accept wildcard characters:False
Applies to:Security & Compliance Center
-RecordsManagementSecurityGroupEmail

This RecordsManagementSecurityGroupEmail parameter specifies the email address of the mail-enabled security group that contains the records managers in the organization.

Type:String
Position:Named
Default value:None
Accept pipeline input:False
Accept wildcard characters:False
Applies to:Security & Compliance Center
-WhatIf

The WhatIf switch doesn't work in Security & Compliance Center PowerShell.

Type:SwitchParameter
Aliases:wi
Position:Named
Default value:None
Accept pipeline input:False
Accept wildcard characters:False
Applies to:Security & Compliance Center

Inputs

Outputs